Place of Origin:
Profile V Wire Wound Screen Continuous Slotted Jonson Screened Pipe
Wire Wrap Sscreeb is manufactured with V-shaped profile wire which is spirally wound around a cage of longitudinal support rods. Each intersecting point of these wires is fusion welded. The pitch of winding gives different spacing between two adjacent turns of wire. This spacing gives passage for water to enter. The entire process is completed on fully computerized machines.
|Material||Low carbon steel galvanized|
|Slot size||1.0 mm|
|End connection||Welded rings|
|Wire size||118 #|
|Support rod||140 #|
|Wire shape||V shape|
Material: stainless steel 302, 304, 316, 304L, 316L or low carbon galvanized
O.D.: 4, 6, 8, 10, 12 inch and as request.
Slot: 0.1mm - 35mm
Discrepancy: + / - 0.05mm
End Connection: welded rings or thread couplings ( male / female )
Specification of the wrap wire:1*2mm, 2*3mm, 2.2*3.5mm, 3*4.6mm and so on.
Specification of the rod:2.8mm, 3.0mm, 3.8mm, 4.0mm, 4.2mm, 4.5mm, 5.0mm and so on.
Special specification can be made according to your need!
Wre wrap screen pipe specific continuous-slot construction aims to optimize flow rates, minimize clogging and help develop the water-bearing geological formations faster. It is best applied in the following situations:
Geological formations comprised of small, fine particles
Water wells where gravel packs will be installed
Thin aquifers, where maximum open area is required
Large- and small-diameter deep wells
Send your inquiry directly to us