Non Clogging 304 Stainless Steel Wedge Wire Screen For Rotating Fine Grid Filters

Wedge Wire Screen For Rotating Fine Grid Filters

Wedge Wire Screen is manufactured with V-shaped profile wire, which is spirally wound around a cage of longitudinal support rods.

Each intersecting point of these wires if fusion welded.

The pitch of winding gives different spacing between two adjacent turns of wire.

This spacing gives passage for water to enter.

The entire process is completed on fully computerized machines.

Wedge Wire Screen Normal Size:

The wedge wire screen materials: 201, 304, 304L, 316L stainless steel wire and others you enquiry.

The profile wire of wedge wire screen is created by wrapping a profile wire cylindrical around longitudinal placed support rods. All wires and rods are resistance welded at each point of contact.

The numerous combinations of profile wires and support rods, and the wide range of apertures between the wires and rods (fixed or variable) allow us to design a screen according your technical or cosmetic specification.

V-Shaped Slots: Openings shaped like a "v" that open toward the inside of the well tend to allow the particles that are just barely smaller than the width of the slot pass. In other shapes of openings, these particles would get caught in the screen and clog it.

Continuous Slots: The special design gives continuous slot opening across the periphery and length of screen.

Very Large Open Area: This design gives continuous slot and hence the% open area for water to enter is more than 2 times that of conventional slotted pipes of any size and slot opening. This allows more water to enter at much lesser frictional head loss and the efficiency of tube well is improved appreciably.

Better Sand Filtration: Due to specialize manufacturing process, wide range of slot opening is available down to 0.15mm to allow proper slot selection depending upon the size of sand in particular area. This gives better sand control and reduced pump maintenance and longer tube well life.